Please find the step-by-step?pool table installation pictures below:
 |
There are 6 cushion sides, 3 lots of 2 identical cushions. Each cushions side belongs at a specific area, with the identical cushion being at the opposite side?of the table.?When put together, the cushions will?fit perfectly and align with the pockets to form a standard size ball hole. When tighten?the cushions, please?use the screw driver by hand ONLY.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
To assemble the net pockets,?please note, the metal wiring forms the skeleton (shape) of the net, then you drill the screws into the loops at each end of the wire to the underside of the pool table top.
 |
 |
 |
 |
The irregular metals on the leather pockets might cause damage?after being inserted inside the cushions, please clear the extra metals by the tool?as shown on the above two pictures.
 |
 |
 |
 |
The legs of the pool table don?t have threads, they are attached from inside to outside within the box frame. The part that is holding them together is the square?box frame (as shown in the instructions FIG 3)
If the cushions are not perfectly fit to the pre drilled holes on the pool table top, you can easily use any nail (no longer than 50mm) to drill the hole yourself. The outcome is same.
Please find the step-by-step?pool table installation pictures below:
 |
There are 6 cushion sides, 3 lots of 2 identical cushions. Each cushions side belongs at a specific area, with the identical cushion being at the opposite side?of the table.?When put together, the cushions will?fit perfectly and align with the pockets to form a standard size ball hole. When tighten?the cushions, please?use the screw driver by hand ONLY.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
The irregular metals on the leather pockets might cause damage after being inserted inside the cushions, please clear the extra metals by the tool as shown on the above two pictures.
 |
 |
 |
 |
 |
 |
 |
 |
To assemble the net pockets, please note, the metal wiring forms the skeleton (shape) of the net,then you drill the screws into the loops at each end of the wire to the underside of the pool table top.
 |
 |
 |
 |
 |
 |
|
 |
 |
 |